ZJT precast wall panel is to replace traditional wall materials such as traditional brick, hollow block, AAC panel ect. Since Middle East is mainly use hollow block, here would like to make a comparison between zjt precast panel & hollow block.
Item | ZJT precast panel | hollow block |
standarid size(mm) | 2440*610*75/90/100/120/150/200 | 400*200*100 |
density | 375~500 kgs/m3 | 600~800 kgs/m3 |
installation | 40~50 m2/day/worker | 5~7 m2/day/worker |
moisture-proof | yes | no |
fireproof | grade A1 | normal |
ZJT eps cement panel energy.saving wall materials.can increase the usable floor area.Method of anchorage steel structure, high strength of the wall, can increase the height, the overall seismic performance is higher than ordinary masonry wall many times.the board structure is closely,not deformation, metope is not easy to loose, good vibration resistance.
ZJT EPS cement lightweight wall panel can be used as partition , external and internal wall. Suitable for concrete, wooden and steel structure; high middle and low building. This green panel is non-bearing. Usually, can also used for floor.
Common building/project type is: residential buildings, shopping mall, office buildings, complex hotel, KTV, museum ect. Due to Onekin panel excellent fireproof performance, it can be also used as passive fire protection wall, such as fire wall, kitchen wall.
Advantages:
Largest span&Height thin webbed wall
Anti-seismic&Impact Resistant
Fire rated more than 4 hours (Civil Defense Approve)
Waterproof, Moistureproof
No wet work/no plastering
Lightweight, Fast installation one person 40sqm per day
>4.5Mpa compressive strength
Time Saving
Up 7X installation than competition of hollow black./4x dry walls
Zero plastering(stucco+paint or direct installation of tile, marble or 3D wall panel)
Easy MEP conduiting work
Cost Saving
Significantly reduced foundation depth and steel in structural(4X lighter than block and thick plaster-10000sqm walls reduce around 25,000 ton of dead load)
Fewer labor hours (80% reduce labor-3 person team can install 40-60m2 per work day-no plaster)
Transport efficiency (350m2 can carried on one flat bed trailer-hollow block on 90 sqm
Min 2 hours fire rating QCDD approval-132min for 100mm panel (Thomas bell-Wright Dubal Test lab, TUV,SGS&Etc)
Non-toxic
Better impact on wall cross section
Sustainability
U value<0.5( excellent Thermal conductivity)
Better STC rating (38dB-over 51dB in one layer of panel)
Minimal wastage (95% less than block)
Cleaner job site (Minimum scrap cleaning and no wet work at site)
Handing
No wet work-mortar use only betweent 2 panels&panels&plastering required ready to paint)
Lightweight simple manel installation no crane required.
High quality components from reputable branks
No ripples/flat and straight
Can it be used for high rise building?
ZJT lightweight panel is mainly for interior and exterior non bearing wall partition.
1. General industrial buildings, eg., high building, KTV
2. Residential buildings
3. Single house
4. Public construction, eg, Hotels, hospitals, schools
5. The fence of the factory
6. Kitchen, bathroom, and the toilet of indoor wall.
7. Also can paste on tiles and cement mortar.
Contact
sales: zoe zeng
What can we offer?
Competitive advantage products
Refund money in case of any bad quality problem or late delivery
Confidential contract "business secret contract"
Quality assurance contract
Payment by paypal
Free sample offered and small order accepted
After sale service 24h×7